ABB ACS880 Firmware Manual page 630

630 Parameters
No. Name / Range /
Selection
99.202 ESP motor nominal
voltage
0.0 ... 32000.0 V
99.203 ESP motor nominal
frequency
0.00 ... 1000.00 Hz
99.204 ESP motor nominal
speed
-30000.00 ...
30000.00 rpm
99.205 ESP motor nominal
power
0.00 ... 10000.00 kW
99.206 ESP motor nominal
cosphi
0.00 ... 1.00
99.207 ESP motor nominal
torque
0.000 ...
4000000.000 Nm
Description
Defines the nominal motor voltage supplied to the
motor. This setting must match the value on the rating
plate of the motor.
Notes:
• With permanent magnet motors, the nominal
voltage is the BackEMF voltage at nominal speed
of the motor. If the voltage is given as voltage per
rpm, e.g. 60 V per 1000 rpm, the voltage for a
nominal speed of 3000 rpm is 3 × 60 V = 180 V.
• The stress on motor insulation is dependent on
the drive supply voltage. This also applies to the
case where the motor voltage rating is lower than
that of the drive and the supply.
Nominal voltage of the motor.
Defines nominal frequency of the ESP motor. This
setting must match the value on the rating plate of the
motor.
Nominal frequency of the ESP motor.
Defines nominal speed of the ESP motor. This setting
must match the value on the rating plate of the motor.
Nominal speed of the motor.
Defines nominal power of the ESP motor. This setting
must match the value on the rating plate of the motor.
Nominal power of the motor.
Defines nominal cosphi of the ESP motor for an
accurate motor model. The value is not obligatory.
Notes:
• With a permanent magnet or synchronous
reluctance motor, this value is not needed.
• Do not enter an estimated value. If you do not
know the exact value, leave the parameter at zero.
• This parameter cannot be changed while the drive
is running.
Cosphi of the motor.
Defines the nominal shaft torque of the ESP motor.
Nominal motor torque.
Def / Type
FbEq 16b / 32b
0.0 V / real32
10 = 1 V / 10 = 1 V
0.00 Hz / real32
100 = 1 Hz / 100 = 1
Hz
0.00 rpm / real32
100 = 1 rpm / 100 = 1
rpm
0.00 kW / real32
100 = 1 kW / 100 = 1
kW
0.00 / real32
100 = 1 / 100 = 1
0.000 Nm / real32
- Nm / 1000 = 1 Nm