ABB ACS880 Firmware Manual page 238

238 Parameters
No. Name / Range /
Selection
14.6 DIO delayed status
14.8 DI filter time
0.8 ... 100.0 ms
14.8 DIO filter time
0.8 ... 100.0 ms
14.8 DIO filter time
0.8 ... 100.0 ms
14.9 DIO1 function
Output
Input
14.9 DIO1 function
Output
Input
14.11 DIO1 output source
Not energized
Energized
Ready run
Enabled
Started
Description
(Visible when 14.1 Module 1 type
Displays the delayed status of the digital input/outputs
on the extension module. This word is updated only
after activation/deactivation delays (if any are
specified).
Bit 0 indicates the status of DIO1.
Note: The number of active bits in this parameter
depends on the number of digital input/outputs on
the extension module.
Example: 1001b = DIO1 and DIO4 are on, remainder are
off.
This parameter is read-only.
(Visible when 14.1 Module 1 type
Defines a filtering time for parameters
and 14.6 DI delayed status.
Filtering time for DI status parameters.
(Visible when 14.1 Module 1 type
Defines a filtering time for parameters
and 14.6 DIO delayed status. The filtering time will only
affect the DIOs that are in input mode.
Filtering time for DIO status parameters.
(Visible when 14.1 Module 1 type
Defines a filtering time for parameters
and 14.6 DIO delayed status. The filtering time will only
affect the DIOs that are in input mode.
Filtering time for DIO status parameters.
(Visible when 14.1 Module 1 type
Selects whether DIO1 of the extension module is used
as a digital input or output.
DIO1 is used as a digital output.
DIO1 is used as a digital input.
(Visible when 14.1 Module 1 type
Selects whether DIO1 of the extension module is used
as a digital input or output.
DIO1 is used as a digital output.
DIO1 is used as a digital input.
(Visible when 14.1 Module 1 type
Selects a drive signal to be connected to digital
input/output DIO1 of the extension module when
parameter 14.9 DIO1 function
Output is not energized.
Output is energized.
Bit 1 of 6.11 Main status word (page
Bit 0 of 6.16 Drive status word 1 (page
Bit 5 of 6.16 Drive status word 1 (page
= FIO-01)
= FDIO-01)
14.5 DI status
= FIO-11)
14.5 DIO status
= FIO-01)
14.5 DIO status
= FIO-11)
= FIO-01)
= FIO-11)
is set to Output.
192).
192).
192).
Def / Type
FbEq 16b / 32b
- / uint16
10.0 ms / real32
10 = 1 ms / 10 = 1 ms
10.0 ms / real32
10 = 1 ms / 10 = 1 ms
10.0 ms / real32
10 = 1 ms / 10 = 1 ms
Input / uint16
0
1
Input / uint16
0
1
Not energized /
uint32
0
1
2
4
5