ABB ACS880 Firmware Manual page 288

288 Parameters
No. Name / Range /
Selection
20.25 Jogging enable
Not selected
Selected
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
Other [bit]
20.26 Jogging 1 start
source
Not selected
Selected
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
Description
Selects the source for a jog enable signal.
(The sources for jogging activation signals are selected
by parameters 20.26 Jogging 1 start source
Jogging 2 start source.)
1 = Jogging is enabled.
0 = Jogging is disabled.
Note: Jogging can be enabled only when no start
command from an external control location is active.
On the other hand, if jogging is already enabled, the
drive cannot be started from an external control
location (apart from inching commands through
fieldbus).
See section Jogging (page
0
1
Digital input DI1 (10.2 DI delayed
Digital input DI2 (10.2 DI delayed
Digital input DI3 (10.2 DI delayed
Digital input DI4 (10.2 DI delayed
Digital input DI5 (10.2 DI delayed
Digital input DI6 (10.2 DI delayed
Digital input/output DIO1
0).
Digital input/output DIO1
1).
See Terms and abbreviations (page
If enabled by parameter
the source for the activation of jogging function 1.
(Jogging function 1 can also be activated through
fieldbus regardless of parameter 20.25.)
1 = Jogging 1 active.
Note: If both jogging 1 and 2 are activated, the one that
was activated first has priority.
0
1
Digital input DI1 (10.2 DI delayed
Digital input DI2 (10.2 DI delayed
Digital input DI3 (10.2 DI delayed
Digital input DI4 (10.2 DI delayed
Digital input DI5 (10.2 DI delayed
Digital input DI6 (10.2 DI delayed
Digital input/output DIO1
0).
and
99).
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.2 DIO delayed status, bit
(11.2 DIO delayed status, bit
169).
20.25 Jogging enable, selects
status, bit 0).
status, bit 1).
status, bit 02).
status, bit 3).
status, bit 4).
status, bit 5).
(11.2 DIO delayed status, bit
Def / Type
FbEq 16b / 32b
Not selected / uint32
20.27
0
1
2
3
4
5
6
7
10
11
Not selected / uint32
0
1
2
3
4
5
6
7
10