ABB ACS880 Firmware Manual page 278

278 Parameters
No. Name / Range /
Selection
19.17 Local control disable
No
Yes
19.20 Scalar control
reference unit
Hz
Rpm
Description
Enables/disables local control (start and stop buttons
on the control panel, and the local controls on the PC
tool).
WARNING!
Before disabling local control, ensure that the
control panel is not needed for stopping the
drive.
Local control enabled.
Local control disabled.
Selects the reference type for scalar motor control
mode.
See also section Operating modes of the
drive (page 42), and parameter
mode.
Note: This parameter cannot be changed while the
drive is running.
Hz. The reference is taken from parameter
Frequency ref ramp output
control chain).
Rpm. The reference is taken from parameter
ref ramp output (speed reference after ramping and
shaping).
99.4 Motor control
28.2
(output of the frequency
23.2 Speed
Def / Type
FbEq 16b / 32b
No / uint16
0
1
Rpm / uint16
0
1