ABB ACS880 Firmware Manual page 283

No. Name / Range /
Selection
In1P Start; In2 Stop
In1P Start; In2 Stop;
In3 Dir
In1P Start fwd; In2P
Start rev; In3 Stop
Control panel
Description
The sources of the start and stop commands are
selected by parameters
Ext2 in2 source.
The state transitions of the source bits are interpreted
as follows:
State of source 1 State of source 2
(20.8)
0?1
Any
Note: The start signal is always edge-triggered with
this setting regardless of parameter
trigger type.
The sources of the start and stop commands are
selected by parameters
Ext2 in2 source.
The source selected by
determines the direction. The state transitions of the
source bits are interpreted as follows:
State of State of
source 1 source 2
(20.8) (20.9)
0?1 1
0?1 1
Any 0
Note: The start signal is always edge-triggered with
this setting regardless of parameter
trigger type.
The sources of the start and stop commands are
selected by parameters
in2 source and 20.10 Ext2 in3
transitions of the source bits are interpreted as follows:
State of State of
source 1 source 2
(20.8) (20.9)
0?1 Any
Any 0?1
Any Any
Note: The start signal is always edge-triggered with
this setting regardless of parameter
trigger type.
The start and stop commands are taken from the
control panel.
20.8 Ext2 in1 source and
Command
(20.9)
1 Start
0 Stop
20.7 Ext2 start
20.8 Ext2 in1 source and
20.10 Ext2 in3 source
State of Command
source 3
(20.10)
0 Start forward
1 Start reverse
Any Stop
20.7 Ext2 start
20.8 Ext2 in1 source, 20.9 Ext2
source. The state
State of Command
source 3
(20.10)
1 Start forward
1 Start reverse
0 Stop
20.7 Ext2 start
Parameters 283
Def / Type
FbEq 16b / 32b
4
20.9
5
20.9
6
11