ABB ACS880 Firmware Manual page 196

196 Parameters
No. Name / Range /
Selection
b2 Constant speed 3
b3 Constant speed 4
b4 Constant speed 5
b5 Constant speed 6
b6 Constant speed 7
b7...15 Reserved
0000h...FFFFh
6.21 Drive status word 3
b0 DC hold active
b1 Post-magnetizing
active
b2 Motor pre-heating
active
b3 Smooth start active
b4 Rotor position
known
b5 Brake chopper
active
b6 Motor temperature
estimation active
b7...15 Reserved
0000h...FFFFh
6.25 Drive inhibit status
word 2
b0 Follower drive
b1 Application
Description
1 = Constant speed or frequency 3 selected
1 = Constant speed or frequency 4 selected
1 = Constant speed or frequency 5 selected
1 = Constant speed or frequency 6 selected
1 = Constant speed or frequency 7 selected
Drive status word 3.
This parameter is read-only.
1 = DC hold is active (see par. 21.8)
1 = Post-magnetizing is active (see par. 21.8)
1 = Motor pre-heating is active (see par. 21.14)
Reserved
1 = Rotor position has been determined (autophasing
not needed). See section
Brake chopper active. See section
chopper (page 122).
Drive inhibit status word 2. This word specifies the
source of the inhibiting condition that is preventing
the drive from starting. After the condition is removed,
the start command must be cycled. See bit-specific
notes.
See also parameter 6.18 Start inhibit status
6.16 Drive status word
This parameter is read-only.
Note:
• If bit 1 of 6.16 Drive status word 1
the removal of the inhibiting condition, and edge
triggering is selected for the active external
control location, a fresh rising-edge start signal
is required. See parameters 20.2,
• If bit 1 of 6.16 Drive status word 1
the removal of the inhibiting condition, a fresh
rising-edge start signal is required.
1 = A follower is preventing the master from starting.
1 = The application program is preventing the drive
from starting.
Autophasing (page 102).
Brake
word, and
1, bit 1.
is still set after
20.7 and 20.19.
is still set after
Def / Type
FbEq 16b / 32b
1 = 1
- / uint16
1 = 1
- / uint16