ABB ACS880 Firmware Manual page 604

604 Parameters
No. Name / Range /
Selection
Factory
Hand/Auto
PID-CTRL
T-CTRL
Sequence control
96.5 Macro active
Factory
Hand/Auto
PID-CTRL
T-CTRL
Sequence control
96.6 Parameter restore
Done
Restore defaults
Description
Factory macro (see 150).
Hand/Auto macro (see page 152).
PID control macro (see page 155).
Torque control macro (see page 160).
Sequential control macro (see page 163).
Reserved.
Shows which application macro is currently selected.
To change the macro, use parameter
Factory macro (see 150).
Hand/Auto macro (see page 152).
PID control macro (see page 155).
Torque control macro (see page 160).
Sequential control macro (see page 163).
Reserved.
Restores the original settings of the control program,
i.e. parameter default values.
Note: This parameter cannot be changed while the
drive is running.
Restoring is completed.
All editable parameter values are restored to default
values, except
• motor data and ID run results
• parameter 31.42 Overcurrent fault limit
• control panel/PC communication settings
• I/O extension module settings
• fieldbus adapter settings
• encoder configuration data
• application macro selection and the parameter
defaults implemented by it
• parameter 95.21 HW options word 2
• parameter 95.9 Switch fuse controller
• differentiated defaults implemented by
parameters 95.20 HW options word 1
HW options word 2
• user lock configuration parameters
96.100 ... 96.102.
Def / Type
FbEq 16b / 32b
1
2
3
4
5
6
Factory / uint16
96.4 Macro select.
1
2
3
4
5
6
Done / uint16
0
8
and 95.21