ABB ACS880 Firmware Manual page 284

284 Parameters
No. Name / Range /
Selection
Fieldbus A
Embedded fieldbus
M/F link
Application Program
ATF
DDCS controller
20.7 Ext2 start trigger
type
Edge
Level
20.8 Ext2 in1 source
20.9 Ext2 in2 source
20.10 Ext2 in3 source
Description
The start and stop commands are taken from fieldbus
adapter A.
Note: The start signal is always edge-triggered with
this setting regardless of parameter
trigger type.
The start and stop commands are taken from the
embedded fieldbus interface.
Note: The start signal is always edge-triggered with
this setting regardless of parameter
trigger type.
The start and stop commands are taken from another
drive through the master/follower link.
Note: The start signal is always edge-triggered with
this setting regardless of parameter
trigger type.
The start and stop commands are taken from the
application program control word (parameter
Application control word).
Note: The start signal is always edge-triggered with
this setting regardless of parameter
trigger type.
Reserved.
The start and stop commands are taken from an
external (DDCS) controller.
Note: The start signal is always edge-triggered with
this setting regardless of parameter
trigger type.
Defines whether the start signal for external control
location EXT2 is edge-triggered or level-triggered.
Note: This parameter is only effective when parameter
20.6 Ext2 commands is set to
Dir, In1 Start fwd; In2 Start
The start signal is edge-triggered.
The start signal is level-triggered.
Selects source 1 for parameter
For the available selections, see parameter
in1 source.
Selects source 2 for parameter
For the available selections, see parameter
in1 source.
Selects source 3 for parameter
For the available selections, see parameter
in1 source.
20.7 Ext2 start
20.7 Ext2 start
20.7 Ext2 start
6.2
20.7 Ext2 start
20.7 Ext2 start
In1 Start, In1 Start; In2
rev, or Control panel.
20.6 Ext2 commands.
20.3 Ext1
20.6 Ext2 commands.
20.3 Ext1
20.6 Ext2 commands.
20.3 Ext1
Def / Type
FbEq 16b / 32b
12
14
15
21
22
16
Edge / uint16
0
1
Not selected / uint32
Not selected / uint32
Not selected / uint32