ABB ACS880 Firmware Manual page 694

694 Fault tracing
Code Event name /
(hex) Aux. code
FB12 Memory unit
incompatible
FB13 Memory unit
FW
incompatible
FB14 Memory unit
FW load failed
FF61 ID run
0001
0002
Cause
The memory unit attached to the
control unit is incompatible.
The firmware on the attached memory
unit is incompatible with the drive.
The memory unit is empty, or contains
incompatible or corrupted firmware.
Motor ID run was not completed
successfully.
Maximum current limit too low.
Maximum speed limit or calculated
field weakening point too low.
What to do
Power down the control unit.
Attach a compatible memory unit.
Power down the control unit.
Attach a memory unit with compatible
firmware.
Recycle the power to the control unit.
Check the sticker on the memory unit
to confirm that the firmware is
compatible with the control unit
(ZCU-1x/BCU-x2).
Connect Drive Composer PC tool
(version 2.3 or later) to the drive.
Select Tools - Recover drive.
If the problem persists, replace the
memory unit.
Check the nominal motor values in
parameter group 99 Motor
Check that no external control system
is connected to the drive.
Cycle the power to the drive (and its
control unit, if powered separately).
Check that the motor shaft is not
locked.
Check the auxiliary code. The second
number of the code indicates the
problem (see actions for each code
below).
Check settings of parameters
Motor nominal current
Maximum current. Make sure that
30.17 Maximum current
nominal current.
Check that the drive is dimensioned
correctly according to the motor.
Check that SLS function is not
active.
Check settings of parameters
• 30.11 Minimum speed
• 30.12 Maximum speed
• 99.7 Motor nominal voltage
• 99.8 Motor nominal frequency
• 99.9 Motor nominal
Make sure that
• 30.12 Maximum speed
× 99.9 Motor nominal
(0.50 × synchronous speed)
• 30.11 Minimum speed
• supply voltage > (0.66 ×
Motor nominal
data.
99.6
and 30.17
> 99.6 Motor
speed.
> (0.55
speed) >
< 0, and
99.7
voltage).