ABB ACS880 Firmware Manual page 251

No. Name / Range /
Selection
14.39 RO2 OFF delay
0.00 ... 3000.00 s
14.39 RO2 OFF delay
0.00 ... 3000.00 s
14.41 AI2 actual value
-22.000 ... 22.000 mA
or V
14.42 AI2 scaled value
-32768.000 ...
32767.000 mA or V
14.43 AI2 force data
-22.000 ... 22.000 mA
or V
14.44 AI2 HW switch
position
mA
V
Description
(Visible when 14.1 Module 1 type
Defines the deactivation delay for relay output RO2.
See parameter 14.35 RO1 ON
Deactivation delay for RO2.
(Visible when 14.1 Module 1 type
Defines the deactivation delay for relay output RO2.
See parameter 14.35 RO1 ON
Deactivation delay for RO2.
(Visible when 14.1 Module 1 type
Displays the value of analog input AI2 in mA or V
(depending on whether the input is set to current or
voltage).
This parameter is read-only.
Value of analog input AI2.
(Visible when 14.1 Module 1 type
Displays the value of analog input AI2 after scaling. See
parameter 14.50 AI2 scaled at AI2
This parameter is read-only.
Scaled value of analog input AI2.
(Visible when 14.1 Module 1 type
Forced value that can be used instead of the true
reading of the input. See parameter
selection.
Forced value of analog input AI2.
(Visible when 14.1 Module 1 type
Shows the position of the hardware current/voltage
selector on the I/O extension module.
Note: The setting of the current/voltage selector must
match the unit selection made in parameter
unit selection. I/O module reboot either by cycling the
power or through parameter
is required to validate any changes in the hardware
settings.
Milliamperes.
Volts.
= FDIO-01)
delay.
= FIO-01)
delay.
= FAIO-01)
= FAIO-01)
min.
= FAIO-01)
14.22 AI force
= FAIO-01)
14.45 AI2
96.8 Control board boot
Parameters 251
Def / Type
FbEq 16b / 32b
0.00 s / real32
10 = 1 s / 100 = 1 s
0.00 s / real32
10 = 1 s / 100 = 1 s
- / real32
1000 = 1 mA or V /
1000 = 1 mA or V
- / real32
1 = 1 mA or V / 1000 =
1 mA or V
- / real32
1000 = 1 mA or V /
1000 = 1 mA or V
mA / uint16
10
2