ABB ACS880 Firmware Manual page 612

612 Parameters
No. Name / Range /
Selection
500us
2ms
10ms
96.70 Disable adaptive
program
No
Yes
96.100 Change user pass
code
10000000...99999999
96.101 Confirm user pass
code
10000000...99999999
96.102 User lock
functionality
b0 Disable ABB access
levels
b1 Freeze parameter
lock state
Description
500 microseconds.
2 milliseconds.
10 milliseconds.
Disables/enables the adaptive program (if present).
See also section Adaptive programming (page
Note: This parameter cannot be changed while the
drive is running.
Adaptive program enabled.
Adaptive program disabled.
(Visible when user lock is open)
To change the current user pass code, enter a new code
into this parameter as well as
code. A warning will be active until the new pass code
is confirmed. To cancel changing the pass code, close
the user lock without confirming. To close the lock,
enter an invalid pass code in parameter
activate parameter 96.8 Control board
the power.
See also section User lock (page
New user pass code.
(Visible when user lock is open)
Confirms the new user pass code entered in
Change user pass code (page
Confirmation of new user pass code.
(Visible when user lock is open)
Selects the actions or functionalities to be prevented
by the user lock. Note that the changes made take
effect only when the user lock is closed. See parameter
96.2 Pass code.
Note: We recommend you select all the actions and
functionalities unless otherwise required by the
application.
1 = ABB access levels (service, advanced programmer,
etc. [see 96.3]) disabled
1 = Changing the parameter lock state prevented, ie.
pass code 358 has no effect
69).
96.101 Confirm user pass
96.2 Pass code,
boot, or cycle
142).
96.100
612).
Def / Type
FbEq 16b / 32b
500
2000
10000
No / uint16
0
1
10000000 / uint32
1 = 1
10000000 / uint32
1 = 1
- / uint16