ABB ACS880 Firmware Manual page 695

Code Event name /
(hex) Aux. code
0003
0004
0005...0008
0009
000A
000B
000C
000D
000E...0010
0011
0012
0013
0014
0015
FF7E Follower
FF81 FB A force trip
FF82 FB B force trip
Cause
Maximum torque limit too low.
Current measurement calibration
did not finish within reasonable
time.
Internal error.
(Asynchronous motors only)
Acceleration did not finish within
reasonable time.
(Asynchronous motors only)
Deceleration did not finish within
reasonable time.
(Asynchronous motors only) Speed
dropped to zero during ID run.
(Permanent magnet motors only)
First acceleration did not finish
within reasonable time.
(Permanent magnet motors only)
Second acceleration did not finish
within reasonable time.
Internal error.
(SynRM only) Rotor orientation not
correct during the pulse test.
Not possible to perform Advanced
Standstill ID run.
(Asynchronous motors only) Error
in motor data.
Acceleration did not finish within
reasonable time during Autophasing
ID run.
Advanced standstill failure.
A follower drive has tripped.
A fault trip command has been
received through fieldbus adapter A.
A fault trip command has been
received through fieldbus adapter B.
Fault tracing 695
What to do
Check settings of parameter
Motor nominal torque, and the
torque limits in group
Make sure that the maximum torque
limit in force is greater than 100%.
Contact your local ABB
representative.
Contact your local ABB
representative.
Contact your local ABB
representative.
Contact your local ABB
representative.
Contact your local ABB
representative.
Contact your local ABB
representative.
Contact your local ABB
representative.
Contact your local ABB
representative.
Try to perform ID run again.
Contact your local ABB
representative.
Check that nominal power is as
advised in Advanced Standstill ID
run description.
Contact your local ABB
representative.
Check name plate data.
Contact your local ABB
representative.
Contact your local ABB
representative.
Contact your local ABB
representative.
Check the auxiliary code. Add 2 to the
code to find out the node address of
the faulted drive.
Correct the fault in the follower drive.
Check the fault information provided
by the PLC.
Check the fault information provided
by the PLC.
99.12
30 Limits.