ABB ACS880 Firmware Manual page 692

692 Fault tracing
Code Event name /
(hex) Aux. code
D105 Signal
supervision 3
D106 Signal
supervision 3
D113 Out of sync
D200 Cleaning max
warning
D20B Signal
supervision 3
D20C Signal
supervision 3
D20D Signal
supervision 3
D20E Signal
supervision 3
D213 Out of sync
FA81 Safe torque
off 1 loss
Cause
Fault generated by the signal
supervision 6 function.
Fault generated by the signal
supervision 7 function.
One or more of the sync loss
conditions is fulfilled.
Maximum number of cleaning in the
defined time frame has been
exceeded.
Warning generated by the signal
supervision 4 function.
Warning generated by the signal
supervision 5 function.
Warning generated by the signal
supervision 6 function.
Warning generated by the signal
supervision 7 function.
One or more of the sync loss
conditions is fulfilled.
Safe torque off function is active, ie.
STO circuit 1 is broken.
What to do
Check the source of the fault
(parameter 32.217 Supervision 5
signal).
Check the source of the fault
(parameter 32.237 Supervision 7
signal).
Check the following parameters:
• 31.203 Sync loss sample period
• 31.204 Sync loss cos phi filter
time
• 31.205 Sync loss cos phi drop
• 31.206 Sync loss cos phi minimum
level
Check motor and motor cables.
Check parameters 81.51 Cleaning max
event to 81.53 Clean max period
clean maximum protection settings.
Check the source of the warning
(parameter 32.207 Supervision 4
signal).
Check the source of the warning
(parameter 32.217 Supervision 5
signal).
Check the source of the warning
(parameter 32.227 Supervision 6
signal).
Check the source of the warning
(parameter 32.237 Supervision 7
signal).
Check the following parameters:
• 31.203 Sync loss sample period
• 31.204 Sync loss cos phi filter
time
• 31.205 Sync loss cos phi drop
• 31.206 Sync loss cos phi minimum
level
Check safety circuit connections. For
more information, see appropriate
drive hardware manual and
description of parameter
indication run/stop (page
Check the auxiliary code, The code
contains location information,
especially with parallel-connected
inverter modules.
for
31.22 STO
370).