ABB ACS880 Firmware Manual page 282

282 Parameters
No. Name / Range /
Selection
DI5
DI6
DIO1
DIO2
Other [bit]
20.4 Ext1 in2 source
20.5 Ext1 in3 source
20.6 Ext2 commands
Not selected
In1 Start
In1 Start; In2 Dir
In1 Start fwd; In2
Start rev
Description
Digital input DI5 (10.2 DI delayed
Digital input DI6 (10.2 DI delayed
Digital input/output DIO1
0).
Digital input/output DIO2
1).
See Terms and abbreviations (page
Selects source 2 for parameter
For the available selections, see parameter
in1 source.
Selects source 3 for parameter
For the available selections, see parameter
in1 source.
Selects the source of start, stop and direction
commands for external control location 2 (EXT2).
See also parameters 20.7...20.10.
No start or stop command sources selected.
The source of the start and stop commands is selected
by parameter 20.8 Ext2 in1
of the source bits are interpreted as follows:
State of source 1 (20.8)
0?1 (20.7 = Edge )
1 (20.7 = Level )
0
The source selected by
signal; the source selected by
determines the direction. The state transitions of the
source bits are interpreted as follows:
State of source 1 State of source 2
(20.8)
0
0?1 (20.7 = Edge )
1 (20.7 = Level )
The source selected by
forward start signal; the source selected by
in2 source is the reverse start signal. The state
transitions of the source bits are interpreted as follows:
State of source 1 State of source 2
(20.8)
0
0?1 (20.7 = Edge )
1 (20.7 = Level )
0 0?1
1 (20.7
1
status, bit 4).
status, bit 5).
(11.2 DIO delayed status, bit
(11.2 DIO delayed status, bit
169).
20.1 Ext1 commands.
20.3 Ext1
20.1 Ext1 commands.
20.3 Ext1
source. The state transitions
Command
Start
Stop
20.8 Ext2 in1 source is the start
20.9 Ext2 in2 source
Command
(20.9)
Any Stop
0 Start forward
1 Start reverse
20.8 Ext2 in1 source is the
20.9 Ext2
Command
(20.9)
0 Stop
0 Start forward
(20.7 = Edge ) Start reverse
= Level )
1 Stop
Def / Type
FbEq 16b / 32b
6
7
10
11
DI2 / uint32
Not selected / uint32
Not selected / uint16
0
1
2
3