ABB ACS880 Firmware Manual page 481

No. Name / Range /
Selection
8 EVEN 1
8 ODD 1
58.6 Communication
control
Enabled
Refresh settings
Silent mode
58.7 Communication
diagnostics
b0 Init failed
b1 Addr config err
b2 Silent mode
b3 Autobauding
b4 Wiring error
b5 Parity error
b6 Baud rate error
b7 No bus activity
b8 No packets
b9 Noise or addressing
error
b10 Comm loss
b11 CW/Ref loss
b12 Not active
b13 Protocol 1
b14 Protocol 2
b15 Internal error
0000h...FFFFh
58.8 Received packets
0...4294967295
Description
Eight data bits, even parity bit, one stop bit.
Eight data bits, odd parity bit, one stop bit.
Validates any changes in the EFB settings, or activates
silent mode.
Normal operation.
Validates any changed EFB configuration settings.
Reverts automatically to Enabled.
Activates silent mode (no messages are transmitted).
Silent mode can be terminated by activating the
Refresh settings selection of this parameter.
Displays the status of the EFB communication.
This parameter is read-only.
1 = EFB initialization failed
1 = Node address not allowed by protocol
1 = Drive not allowed to transmit
0 = Drive allowed to transmit
Reserved
1 = Errors detected (A/B wires possibly swapped)
1 = Error detected: check parameters
1 = Error detected: check parameters
1 = 0 bytes received during last 5 seconds
1 = 0 packets (addressed to any device) detected during
last 5 seconds
1 = Errors detected (interference, or another device
with the same address on line)
1 = 0 packets addressed to the drive received within
timeout (58.16)
1 = No control word or references received within
timeout (58.16)
Reserved
1 = Protocol-dependent status information
1 = Protocol-dependent status information
1 = Problem with calls to drive control program
Displays a count of valid packets addressed to the
drive.
During normal operation, this number increases
constantly.
Can be reset from the control panel by keeping Reset
depressed for over 3 seconds.
Number of received packets addressed to the drive.
Parameters 481
Def / Type
FbEq 16b / 32b
2
3
Enabled / uint16
0
1
2
- / uint16
58.04 and 58.05
58.05 and 58.04
1 = 1
0 / uint32
1 = 1 / 1 = 1