Oven Blanket (Right Side) Installation; Oven Blanket (Left Side); Oven Blanket (Left Side) Removal - Stratasys FORTUS 360mc Service Manual

Oven Blanket (right side) Installation

Tools and Materials Required
• 7/16-inch open end wrench
Procedure
• Install the new blanket in the reverse order of the steps above.
Take care not to rip or tear the new oven blanket on any of the oven
studs. Also, check to make sure the Z stage is not rubbing against the
oven blanket.

Oven Blanket (left side)

Oven Blanket (left side) Removal

Tools and Materials Required
• 7/16-inch wrench
Procedure
1.
Move the Z stage to the middle of the oven in order to access the nuts and washer that
hold the oven blanket to the oven.
2.
Power down the system and allow the system to cool to room temperature before
.
proceeding (See
Warning: Make sure power is removed from the system. High
voltage may exist if the UPS is not powered off.
3.
Remove the upper and lower left side panels. (See
4.
Remove the eight nuts (7/16-inch wrench) and washers that hold the oven blanket to the
oven. (See Figure
FORTUS 360mc/400mc Service Manual
"System Power Down" on page
5-75.)
.
5-8)
"Panel Installation" on page 5-7.)
5-107