Right And Left Side Oven Blowers - Stratasys F123 Series Manual

Customer Replaceable Units
2. Align the touchscreen's standoff fasteners (4) with the corresponding slots in the mounting
plate and gently press it down until it is fully seated. See
3. Use a 3 mm hex wrench to reinstall the touchscreen mounting screw (1). See

Right and Left Side Oven Blowers

Required Tools
• 2.5 mm hex wrench
• 3 mm hex wrench
Removing the Oven Blower
1. Power OFF the printer. See
2. Remove the rear panel. See
3. Remove the side panels. See
If all four of the standoff fasteners are not properly installed, the mounting screw
holes on top of the brackets will not align.
Figure 39: Mounting Plate Slots and Alignment
Standoff
Fasteners
Mounting
Plate Slots
Touchscreen calibration should be performed after proper touchscreen operation
is confirmed. See
© Copyright 2021 Stratasys. All rights reserved.
"Touchscreen Calibration" (page
"Powering Off" (page
"Removing the Rear Panel" (page
"Right and Left Side Panels" (page
Right and Left Side Oven Blowers
Figure 39.
Mounting
Screw Hole
160).
181).
182).
183).
Figure 38.
Page 197