X-Axis Guide Rod/Pillow Block
X-Axis Guide Rod/Pillow Block Bearing Removal
Tools and Materials Required
• 3/32-inch hex key
• 9/64-inch hex key
• 11/32-inch hex key
• 5/32-inch hex key
• 3/16-inch hex key
• 9/64-inch hex key
Procedure
1.
Unload material from the system.
2.
Power down the system. (See
3.
Remove the top panels from the system. (See
4.
Remove the upper left and upper right side panels. (See
5.
Disconnect electrical connectors to left hand side exhaust fans by pulling on the
connector.
6.
Loosen, but do not remove, the 3 screws that hold the left side fan bank to the system
frame using a 5/32-inch hex key.
FORTUS 360mc/400mc Service Manual
"System Power Down" on page
Figure 5-28: Exhaust Fan Electrical Connector
5-8.)
"Panel Removal" on page
"Panel Removal" on page
5-6.)
5-6.)
5-44