Panel Installation - Stratasys FORTUS 360mc Service Manual

Panel Installation

Tools and Materials Required
• T-25 Torx wrench
• 5/32-inch hex key
• #2 Phillips screwdriver
Procedure
1.
Side Panels (see
• Install the lower side panel and tighten four screws to secure the panel in
• Install the upper side panel and tighten four screws to secure the panel in
2.
Back Panels:
• Install the middle back panel and lower back panels and tighten the
• See
3.
Top Panels (Figure 5-1 on page
• Position the top left panel and the top right panel and tighten the retaining
• Position the top center panel on the system. Make sure the sensor flag is
FORTUS 360mc/400mc Service Manual
Figure 5-1 on page 5-5):
place.
place.
retaining screws.
Figure 5-1 on page 5-5
5-5):
screws secure the panel in place.
aligned with the gap in the cover sensor and then install and tighten the
screws.
for Torx screw locations.
5-7