RIGHT AND LEFT SIDE OVEN BLOWERS
Required Tools
2.5 mm hex wrench
•
3 mm hex wrench
•
Removing the Oven Blower
1.
Power OFF the printer. See
2.
Remove the rear panel. See
3.
Remove the side panels. See
4.
Right-side oven blower only: Using a 2.5 mm hex wrench, remove the mounting screws (2)
that secure the center side bezel and remove it from the printer.
Figure 7-28:
5.
Disconnect the oven blower motor connector from the I/O board (J39 - right blower, J37 - left
blower).
Note: Take note of the wire routing configuration for ease of installation.
"Powering Off" on page
"Removing the Rear Panel" on page
"Right and Left Side Panels" on page
Center Side Bezel Mounting Screw Locations
169.
170.
171.
186