24/48 Volt Power Supply Installation - Stratasys FORTUS 360mc Service Manual

24/48 Volt Power Supply Installation

Tools and Materials Required
• #2 Phillips screwdriver
Procedure
1.
Properly position the 24/48 volt power supply in the system.
2.
Install and tighten the 24/48 volt power supply mounting screws.
3.
Attach all electrical connectors to the 24/48 volt power supply.
4.
Carefully slide the UPS/power supply tray into the lower bay until it reaches the end of
its travel.
5.
Tighten the two clamp screws for the UPS/power supply tray.
6.
Install the lower back panel. (See
7.
Power up the system to verify operation. (See
Tray
FORTUS 360mc/400mc Service Manual
"Panel Installation" on page
Figure 5-53: UPS and 24/48 Volt Power Supply Tray
5-7.)
"System Power Up" on page 5-9.)
5-82