Y Bock Installation
Tools and Materials
• 5/32-inch hex key
Procedure
1.
Inspect the three Y block filament tubes. Check for damage, kinks, squared ends, etc.
2.
Position the Y block in the system.
Mounting Screws
3.
Install and tighten the two mounting screws to secure the Y block using 5/32-inch hex
key.
4.
Attach the air dryer tube to the Y block by firmly pressing the tube into the Y block
fitting.
5.
Attach the filament tubes to the Y block by firmly pressing the tubes into the Y block
fittings for 4-bay systems, make sure that the tubes from the canister bays do not
crossover each other.
6.
Check to make sure that the tubes are firmly anchored in the fittings by gently trying to
pull the tubes free of the Y block. The tubes should stay attached.
7.
Install the middle back panel. (See
8.
Power up the system. (See
FORTUS 360mc/400mc Service Manual
Figure 5-81: Y Drive Block and Fix Labels
"Panel Installation" on page
"System Power Up" on page
Filament Tubes
From Canisters
Air Dryer Tube
5-7.)
5-9.)
Filament Tube
To Head
5-117