Z Drive Motor Installation
Tools and Materials Required
• 5/32-inch hex key
• Replacement cable ties
Procedure
1.
Install the motor onto the adjusting plate. Make sure the motor fits flush on the plate. (See
Figure 5-36 on page
2.
Install and tighten the motor mount screws.
3.
Route the motor cables to the MIO board. Remove slack and secure the cables using cable
ties.
4.
Plug the motor cables into MIO board. Make sure the connections are secure.
5.
Install the Z drive belt. (See
6.
Set the Z belt tension. (See
7.
Perform the Platen Level Adjustment. (See
8.
If the platen level was adjusted, perform the Upper Z Stage Hard Stop Adjustment.
(See
"Upper Z Stage Hard Stop Adjustment" on page
FORTUS 360mc/400mc Service Manual
5-54.)
"Z Stage Drive Belt Installation" on page
"Z Stage Belt Tension" on page
6-28.)
"Platen Level Adjustment" on page
6-16.)
5-68.)
6-12.)
5-55