Customer Replaceable Units
Right and Left Side Oven Blowers
Required Tools
•
2.5 mm hex wrench
•
3 mm hex wrench
Removing the Oven Blower
1. Power OFF the printer. See
2. Remove the rear panel. See
3. Remove the side panels. See
4. Disconnect the oven blower motor connector from the I/O board (J39 - right blower, J37 -
left blower).
5. Using a 3 mm hex wrench, remove the mounting screws (5) that secure the blower
assembly to the oven frame, see
Note:
Take note of the wire routing configuration for ease of installation.
© Copyright 2020 Stratasys. All rights reserved.
"Powering OFF the Printer" (page
"Removing the Rear Panel" (page
"Removing the Side Panels" (page
Figure 30 (page
Right and Left Side Oven Blowers
159).
161).
162).
177).
Page 176