Z Stage Drive Belt Installation - Stratasys FORTUS 360mc Service Manual

Z Stage Drive Belt Installation

Tools and Materials Required
• 5/32-inch hex key
• 7/16-inch open end wrench
• 3/16-inch hex key
Procedure
1.
Install the belt on pulleys/idlers.
2.
Turn the belt tension adjusting screw to remove excess slack from belt.
Motor Pulley
Motor Mount
Adjusting Plate
Screws
3.
Set the Z stage belt tension. (See
4.
Perform the Platen Level Adjustment. (See
5.
If the platen level was adjusted, perform the Upper Z Stage Hard Stops Adjustment.
(See "Upper Z Stage Hard Stop Adjustment" on page
6.
Reinstall the side panels. (See
FORTUS 360mc/400mc Service Manual
(Figure
Figure 5-47: Z Stage Belt/Pulley Diagram
Lead Screw Pulleys
"Z Stage Belt Tension" on page
"Panel Installation" on page
5-47.)
Idler Pulleys
Locknut
Tension Adjusting Screw
"Platen Level Adjustment" on page
6-16.)
5-7.)
6-28.)
6-12.)
5-68