Tip Air Deflector Adjustment
Tools and Materials Required
• 7/64-inch hex key
Procedure
Warning: Head area is hot. Use proper protective gear to avoid
burns.
1.
Tip Air Deflector must be installed with the perforated side to the rear of the system.
2.
Loosen the four screws holding the tip air deflector in place.
3.
Adjust the tip air deflector height its bottom edge is at the top edge of the model side
Teflon tip shield. (See
4.
Tighten the 4 mounting screws.
(2 in Front and 2 in Back)
Support Tip at Active Position
FORTUS 360mc/400mc Service Manual
Figure
6-26.)
Figure 6-26: Tip Air Deflector Adjustment
Mounting Screws
Support Tip at Inactive Position
6-37