Internal Vacuum Pump Installation
Tools and Materials
• 7/16-inch wrench open end wrench
Procedure
1.
Thread four rubber mount fittings (shipped with pump) into the vacuum pump feet.
2.
Position the vacuum pump on the pump mount.
3.
Secure the pump to the mount with four mounting nuts (shipped with pump).
4.
Connect the vacuum tubes to the pump connections.
5.
Connect the electrical harness to the pump harness.
6.
Make sure the electrical harness and vacuum tubes do not interfere with moving parts or
contact hot surfaces. Make sure the vacuum tubes are securely fastened to the fittings.
7.
Install the upper and lower right side panels. (See
8.
Power up the system. (See
FORTUS 360mc/400mc Service Manual
"System Power Up" on page
"Panel Installation" on page
5-9.)
5-7.)
5-119