Electronic Components
Display Panel
Display Panel Removal
Tools and Materials Required
• T-25 Torx
• 3/16-inch hex key
Prerequisite Procedures
• Power down the system. (See
• Open/Remove the right side panels. (See
Procedure
For Titan:
(Figure
1.
Loosen and remove the 6 right front cover mount screws (3 along inner lip (Torx - 25) of
the cover, 3 internal (3/16-inch hex key with washers) along door frame).
2.
Lift the right front cover to remove it from the system.
3.
Disconnect the Display interface cable from the bottom of the Display assembly.
4.
Loosen and remove the 4 Display mount screws (5/32-inch hex key) - remove the
Display.
FORTUS 360mc/400mc Service Manual
"System Power Down/Power Up" on page
10-12)
The Display is not attached to the cover.
"Panel Removal" on page
5-8.)
5-6.)
10-27