Computer Installation
Tools and Materials Required
• 9/16-inch hex key
Procedure
1.
Position the computer into the system while aligning the mounting screws. When in
place, slide the computer toward the front of the system.
2.
Tighten the four mounting screws.
3.
Attach the power cord and interface cables to the computer.
4.
Power up the system. (See
5.
Load the controller software. (See
6.
Install the side panels. (See
7.
Run the XYZ Tip Offset calibration to verify system operation. (See
page
6-6.)
FORTUS 360mc/400mc Service Manual
"System Power Up" on page
"Upgrade Controller Software" on page
"Panel Installation" on page
5-9.)
3-20.)
5-7.)
"XYZ Tip Offset" on
5-86