And Y Belt Installation - Stratasys FORTUS 360mc Service Manual

X and Y Belt Installation
Tools and Materials Required
• 3/8-inch open end wrench
• 3/32-inch hex key
If required, belts can be trimmed to correct length.
Procedure
1.
Attach one end of the new Y belt to a tensioner. Tighten the clamp bolts. (See
14.)
The Y belt is the bottom shorter belt.
2.
Insert the threaded screw of the assembled tensioner into the bore at the front tensioner
mounting location. Install a Nylock nut onto the threaded screw of the tensioner. Tighten
the nut until at least the first two threads of the tensioner screw are exposed.
Make sure the locating rod on the XY gantry slides into bore of the
tensioner.
3.
Thread the Y belt through the pulleys. (See
4.
Attach the free end of the Y belt to a tensioner. Tighten the clamp bolts.
FORTUS 360mc/400mc Service Manual
Figure 5-14: Belt Tensioner Assembly
Preferred Assembly
Up to One Tooth Adjustment Allowed
to Compensate for a Short Belt
(Figure 5-13 on page
Figure 5-
5-25))
5-26