Initial Power Up, Network Configuration And System Activation - Stratasys FORTUS 360mc Service Manual

Initial Power Up, Network Configuration and System Activation

1.
Turn the system circuit breaker to ON.
2.
Turn the UPS switch to ON.
3.
Verify that the UPS has powered ON and that the computer has booted.
4.
Press the green start button on the operator panel.
• The operator panel will display the following message when the computer
5.
Obtain the setup code from the customer or from Stratasys.
FORTUS 360mc/400mc Service Manual
Figure 3-21: System Power Up
Figure 3-22: Operator Panel
boot up is complete:
FDM 360mc or 400mc
*Download a Setup Code to Proceed*
>Network Configuration
UPS On/Off Button
Green Start
Button
UPS
Switch
System Circuit
Breaker
3-14