Oven Blower Installation
Tools and Materials Required
• T-25 Torx wrench
• 1/4-inch nut driver
• 7/16-inch wrench
Procedure
1.
Place a new blower gasket on a blower.
2.
Assemble the blower motor and blower gasket to the blower mount. install and tighten
three mounting screws.
Make sure blower gasket is properly seated between the blower and
blower mount.
3.
Assemble the second blower motor and blower gasket to the blower mount. Install and
tighten three mounting screws in the same manner.
4.
Place the new mount gasket on the blower/mount assembly.
Blower Motor
Blower Gasket
5.
Install the gasket and blower/mount assembly into system. Install and tighten five
mounting screws.
Make sure the blower mount gasket is properly seated between the
blower mount and oven.
FORTUS 360mc/400mc Service Manual
Figure 5-60: Blower Mount Assembly and Gasket
Blower Mount
Blower Mount Gasket
Mounting Screws
(3X)
5-91