Oven Thermocouple Installation - Stratasys FORTUS 360mc Service Manual

Oven Thermocouple Installation

Tools and Materials Required
• T-10 Torx wrench
• Wire cutter
• 11/32-inch hex key
• Cable Ties
Procedure
1.
Push the thermocouple connector end and wiring through the opening between the back
and left bellows rails.
• Pull the wiring tight on the outside of the oven to remove all slack from
Back Bellow Rail
Opening
Left Bellows Rail
2.
Secure the thermocouple to the bracket beneath the X-axis bellows with two mounting
screws.
• Before tightening, route the wiring below the bracket and then up behind
FORTUS 360mc/400mc Service Manual
(Figure 5-63).
inside the oven.
Figure 5-63: Thermocouple Wiring
the bracket in the corner gap.
Heat Shield
5-94