Filament Drive Installation
Tools and Materials
• 3/4-inch wrench
• 5/32-inch hex key
• 1/8-inch hex key
Procedure
1.
Install a spring, followed by a washer on each of the filament drive alignment pins. The
spring will rest on the filament drive. The washer sits on top of the spring.
2.
Attach the filament tube to the filament drive.
3.
Support the filament drive from the underside and install a spring and a washer onto
each filament drive alignment rod.
4.
Guide the filament tube up through the center hole in the filament drive support, while
sliding the filament drive into position.
Interface Cable
Connection
FORTUS 360mc/400mc Service Manual
Figure 5-79: Filament Drive
Filament Tube
Washer (2X)
Spring (2X)
Alignment Pin (2X
Detent Lever
5-114