Oven Heaters
Oven Heaters Removal
Tools and Materials Required
• T-15 Torx wrench
• T-25 Torx wrench
• 1/8-inch hex key
• 7/16-inch open end wrench
• Phillips screwdriver
Procedure
1.
Raise the platen to its upper position to gain access to various screws during the removal
procedure.
2.
Power down the system. (See
3.
Remove the lower left side panel and the upper and lower right side panels. (See
Removal" on page
4.
Remove one nut that secures the heater cable clamp using a 7/16-inch wrench. (See
Figure
5-67.)
5.
Loosen the two screws (Phillips screwdriver) on the wiring harness clamp so the heater
wiring is loose in the clamp.
Heater Cable
Clamp
FORTUS 360mc/400mc Service Manual
"System Power Down" on page
5-6.)
Figure 5-67: Wiring Harness Clamps
5-8.)
"Panel
Wiring Harness
Clamp
5-98