Oven Blower
Oven Blower Removal
Tools and Materials Required
• 7-16-inch open end wrench
• T-25 Torx wrench
• 1/4-inch nut driver
Procedure
It is recommended that both oven blowers be replaced anytime a
blower replacement is required.
1.
Move the Z stage to the middle of the oven.
2.
Power down the system. (See
3.
Remove the right side panels. (See
4.
Remove the lower and middle back covers. (See
5.
Remove two oven blanket nuts (7-16-inch open end wrench) and washers.
FORTUS 360mc/400mc Service Manual
"System Power Down" on page
"Panel Removal" on page
Figure 5-57: Oven Blanket
5-8.)
5-6.)
"Panel Removal" on page
Oven Blanket
Nuts and Washers
5-6.)
5-88