X-Axis Guide Rod / Pillow Block
X-Axis Guide Rod / Pillow Block Installation
Tools and Materials Required
• Set of basic service tools
• Krytox Grease
• Medium strength threadlocker
• Replacement the pillow block/bearing assemblies and guide rod assemblies as
required. The bearing assemblies can be individually replaced. If a guide rod
assembly is replaced, replace both bearing assemblies on the guide rod.
• Guide Rod Assembly PN 10122201
• Bearing Assembly PN 10212301
Procedure
1.
Apply a thin coat of Krytox grease to guide rods.
2.
Install new pillow block/bearing assemblies onto guide rods.
• With the label facing towards the inside, slide (2) bearing blocks onto each
3.
Position Guide Rod assemblies for installation.
4.
Install, but do not tighten, Guide Rod mounting screws.
5.
Grease Bearing assemblies.
FORTUS 360mc/400mc Service Manual
Caution: do not remove plastic plug from bearing assembly. It is
used to retain the bearing rollers.
guide rod. This will push out the large plastic plugs.
Figure 10-7: X-Axis Guide Rod/Bearing Installation
Do not use medium strength threadlocker on Guide Rod mounting
screws.
(Figure
10-7)
(Figure
10-7)
10-20