Panel Removal - Stratasys FORTUS 360mc Service Manual

Panel Removal

Tools and Materials Required
• T-25 Torx wrench
• 5/32-inch hex key
• #2 Phillips screwdriver
Procedure
1.
Side Panels (see
• There is an upper and lower side panel on each side of the system.
• Loosen four retaining screws for each panel and then lift the panel up to
2.
Back Panels (see
• There are three individual back panels, a middle back panel, an upper
• Remove the retaining screws holding the panels in place and remove the
3.
Top panels (see
A.
B.
C.
FORTUS 360mc/400mc Service Manual
Figure 5-1 on page 5-5):
remove it from the system.
Figure 5-1 on page
back panel and a lower back panel.
panels from the system. The upper back panel does not need to be
removed.
Figure 5-1 on page 5-5):
There are three individual top panels on the system, a top left, top
center, and top right.
The top center panel must be removed first by removing the
retaining screws and lifting the panel from the system.
After the top center panel has been removed the retaining screws
can be removed from the remaining top panels so they can be
removed from the system.
5-5):
5-6