Datalogic AMT58 Series Manual page 372

AMT58x-DN DeviceNET®
10h Device state conflict
13h Not enough data
14h Attribute not supported
15h Too much data
16h Object does not exist
20h Invalid parameter
For any further information on general error codes refer to the
publication "The CIP Networks Library. Volume I. Common Industrial
Protocol (CIP™)".
32
The device's
mode/state prohibits
execution of the requested
service.
The service did not supply
enough data to perform the
specified operation.
The attribute specified in the
request is not supported.
The service supplied more
data than was expected.
The object specified does not
exist in the device.
A parameter associated with
the request was invalid. This
code is used
parameter does not meet the
requirements of
specification and/or
requirements defined in an
Application
Specification.
current
the
when a
this
the
Object