Chapter 1. Safety Summary; Safety; Electrical Safety - Datalogic AMT58 Series Manual

CHAPTER 1
SAFETY SUMMARY

SAFETY

•
•
•
•
•
•
•

ELECTRICAL SAFETY

•
•
•
- before handling and installing the equipment, discharge electrical charge from
- power supply must be stabilized without noise; install EMC filters on device
- always use shielded cables (twisted pair cables whenever possible);
- avoid cables runs longer than necessary;
- avoid running the signal cable near high voltage power cables;
- mount the device as far as possible from any capacitive or inductive noise source;
- to guarantee a correct working of the device, avoid using strong magnets on or
- minimize noise by connecting the shield and/or the connector housing and/or the
Always adhere to the professional safety and accident prevention regulations
applicable to your country during device installation and operation;
installation and maintenance operations have to be carried out by qualified per-
sonnel only, with power supply disconnected and stationary mechanical parts;
device must be used only for the purpose appropriate to its design: use for pur-
poses other than those for which it has been designed could result in serious per-
sonal and/or the environment damage;
high current, voltage and moving mechanical parts can cause serious or fatal
injury;
warning! Do not use in explosive or flammable areas;
failure to comply with these precautions or with specific warnings elsewhere in
this manual violates safety standards of design, manufacture, and intended use of
the equipment;
Datalogic assumes no liability for the customer's failure to comply with these
requirements.
Turn OFF power supply before connecting the device;
connect according to explanation in section "Electrical connections";
in compliance with 2014/30/EU norm on electromagnetic compatibility, following
precautions must be taken:
your body and tools which may come in touch with the device;
power supply if needed;
shield the device from noise source if needed;
near by the unit;
frame to ground. Make sure that ground is not affected by noise. The connection
point to ground can be situated both on the device side and on user's side.
1
INSTRUCTION MANUAL