Interconnecting The Ports In The Inspector Window - Datalogic AMT58 Series Manual

INTERCONNECTING THE PORTS IN THE INSPECTOR WINDOW

To interconnect the ports, follow these steps:
1. In the Device view tab or Network view tab, select the PROFINET device or PROF-
2. In the Table Area of the Hardware and network editor select the port which you
3. In the Inspector window, navigate to the Properties tab and select Port intercon-
4. In the Local port section, you can find the settings at the local port.
5. In the Partner port area, select the drop-down list for Partner port in order to dis-
Figure 5. Interconnecting port 1
Figure 6. Interconnecting port 2
INET interface.
want to configure (Port 1 and Port 2).
nection in the navigation area.
play the available partner ports and make a selection.
INTERCONNECTING THE PORTS IN THE INSPECTOR WINDOW
83
INSTRUCTION MANUAL