Datalogic AMT58 Series Manual page 363

6 Total measuring range
This parameter allows the operator to convert the measuring range of
the encoder to a different measuring range required by the
application.
Enabled if 4 Scaling function control
Allowed values are equal to or lower than Physical total resolution.
Physical total resolution =
Physical number of revolutions.
ATTENTION
We advise values which are power of 2 (2
8192,...) to be set in
range parameters in order to avoid counting errors.
If 5 Measuring units/rev
are changed, 7 Preset value
with new resolution.
7 Preset value
7 Preset value function is meant to assign a certain value to a
desired physical position of the encoder shaft. When the axis
reaches the set physical position the
7 Preset value must not be greater than the
to avoid run-time errors.
8 Physical resolution/revolution
This parameter defines the hardware number of distinguishable steps
per revolution.
If you need to set a different resolution see
parameter.
9 Physical number of revolutions
This object defines the hardware number of revolutions.
Physical total resolution =
Physical number of
If you need to set a different total resolution see
units/rev e 6 Total measuring
10 Alarms
An alarm is set when a bit indicating a fault is set to true (high).
See 11 Supported alarms
= "Enabled".
8 Physical resolution/revolution
5 Measuring units/rev
and/or 6 Total measuring range
parameter has to be set in accordance
7 Preset value
8 Physical resolution/revolution
revolutions.
range.
values.
AMT58x-DN DeviceNET®
n
: 2, 4, ..., 2048, 4096,
and 6 Total measuring
parameters
is transmitted.
6 Total measuring range
5 Measuring units/rev
5 Measuring
* 9
* 9
23