Chapter 5. Getting Started; Quick Start Information - Datalogic AMT58 Series Manual

CHAPTER 5
GETTING STARTED

QUICK START INFORMATION

The following instructions allow the operator to quickly and safely set up the device in a
standard operational mode.
For complete and detailed information please read the mentioned pages thoroughly.
•
•
•
•
•
•
•
•
•
NOTE
Mechanically install the device, see
execute the electrical and network connections, see
;
on page 7
switch on the +10Vdc +30Vdc power supply;
install the GSDML file, see "
insert the Datalogic module and type of telegram in the PROFINET-IO system, see
"
Adding a node to the project" on page 21
set the device name, see "
set the IP address and the subnet mask to the node, see "
and the IP address" on page 26
to set the parameters, enter the Module parameters page, see "
; in this page it is possible, for example, to set the singleturn reso-
ters" on page 24
lution or the total resolution, to enable the scaling function or to change the
counting direction; after entering new values, you must download the parameters
to the device; for the complete list of the default parameters see
ter List, starting on page 103
to enable the scaling function, change the counting direction and execute the pre-
set, the Class 4 functionality
.
tionality" on page 64
It is possible to configure the parameters also by entering the web server
via browser (see " Integrated Web Server" on page 90 ): in the Set Encoder
Registers page (see " Setting the Parameters" on page 94 ), the operator can
either enter the desired value or set it through the drop-down box in the
input field under the WRITE column; then he has to press the button
between the boxes to confirm. The value that is currently set can be found
in the box on the right under the READ column.
Mechanical Installation, starting on page 4
Installing the GSDML file" on page 20
;
Setting the device name and the IP address" on page 26
; the default address is 0.0.0.0;
;
parameter must be enabled (="1"), see "
Electrical Connections, starting
;
Setting the device name
Module parame-
Default Parame-
Class 4 func-
INSTRUCTION MANUAL
;
;
13