Module Parameters - Datalogic AMT58 Series Manual
Absolute encoders
Hide thumbs
Also See for AMT58 Series:
- Instruction manual (63 pages) ,
- Mounting instructions (2 pages) ,
- Manual (2 pages)
Table of Contents
Advertisement
GETTING STARTED
Module parameters
Press the Device view changeover switch in the Hardware and network editor to enter
the Device view working area, then select the device you need to configure in the drop-
down box on the top left of the graphic area. Select the Module Access Point field in
Device view. In the Properties inspector window, General tab, press the Module param-
eters menu option to see and set the encoder's parameters if required.
The parameters listed in this page are sent at each switching on.
You can change the value of each parameter in the edit field. The new value will be
transmitted to the Device at switching on.
You can change the value of the module parameters also while the device is operational
in the Cyclic Data Exchange mode via the Watch table. Please note that the value how-
ever will be overwritten at switching on by the value set in the Module parameters
tabbed page.
For a comprehensive description of the parameters and how to set them properly refer
to the specific explanation under
Figure 7. Module parameters
24
AMT58...PN
Encoder Parameters, starting on page 62
.
Advertisement
Chapters
Table of Contents
