Datalogic AMT58 Series Manual page 212

GETTING STARTED
To get started with the diagnostic functions you must go online. To do this you must
press the Go online command in the Online menu bar (see also "
connection (Online mode)" on page 28
Figure 13. Going online
The Diagnostics working area window contains information about the encoder, statuses,
events, etc.
Under Functions press Reset to factory settings.
Figure 14. Reset to factory settings
Enter the MAC address of the encoder you need to reset (it is written on the encoder
label) and then press the Reset button to confirm.
When the operation is carried out, you will find the value 0.0.0.0 under the IP address
item and three dashes under the PROFINET device name item, they are followed by the
message "No device name assigned".
32
AMT58...PN
).
Establishing an online