Datalogic AMT58 Series Manual page 358

AMT58x-DN DeviceNET®
5.4 Save parameter with RSNetWorx
Properties window allows you to set device parameters.
After this operation is carried out, data is stored in RAM memory
only. In case of "Node reset", "Node restore" or power off,
parameters will be lost.
To save new parameters permanently you must start the CLASS
INSTANCE EDITOR; to do this right-click the encoder icon in the
Graph pane and select the Class Instance Editor... command.
In the Class Instance Editor window enter values expressed in
hexadecimal notation as shown in the Figure below. When setting up
is carried out, press the Execute button: data will be downloaded to
the encoder and saved.
Soon afterwards, The execution was completed message will appear
to confirm that data has been downloaded and saved properly.
Close the Class Instance Editor window pressing the Close button.
18