Datalogic AMT58 Series Manual page 349

4.4 Connection cap with M12 connectors
BC-FD-C connection cap is fitted with two M12 connectors with pin-
out in compliance with DeviceNet standard.
Therefore you can use standard DeviceNet cables commercially
available.
M12 connector
A coding
(frontal side)
Pin
Case
1
2
3
4
5
1
CAN Shield is also connected to pin 1 to allow the connection of
the shield even if the plug connector has a plastic case.
4.5 Connection of the shield
Disentangle and shorten the shielding 1 and then bend it over the
part 2; finally place the ring nut 3 of the connector. Be sure that the
shielding 1 is in tight contact with the ring nut 3.
male
(BUS IN)
1
+10VDC +30VDC Supply
0 VDC Supply voltage
AMT58x-DN DeviceNET®
female
(BUS OUT)
Function
CAN Shield
voltage
CAN High
CAN Low
9