Datalogic AMT58 Series Manual page 191

PWR Power LED (green)
It shows the power supply state.
PWR LED DESCRIPTION
OFF
ON
MS Module Status LED
It shows the state of the Profinet device.
MS LED DESCRIPTION
OFF
ON green Normal operation
FLASHING
Diagnostic event(s)
green once
ON red
MS LED DESCRIPTION
Alternating
red/green
L/A Link/Activity LED for port 1 P1 (green)
It shows the state and the activity of the physical link (port 1 P1).
LED DESCRIPTION
OFF
ON green
FLICKERING
green
While the encoder is performing its power up testing, the NS network status indicator
and the MS module status indicator shall perform a test sequence.
The encoder power supply is switched
Power OFF
OFF.
The encoder power supply is switched
Power ON
ON.
(green / red)
The power supply is switched OFF or the
Not initialized device is in
"SETUP state" on page
The device has shifted from the
state (see
Diagnostic event(s) active
The device is in
Exception error
"EXCEPTION state" on page
A major internal error has occurred (this
Fatal event indication is combined with the red NS
Network Status LED)
Do NOT power off the encoder. Switching
Firmware update the encoder off during this phase could
cause permanent damage
No link Link not active, no activity on port 1 P1
Link Port 1 P1 link active, no activity
Activity Port 1 P1 link active, activity on port 1 P1
DIAGNOSTIC LEDS
MEANING
MEANING
SETUP or NW_INIT state (see
12).
NW_INIT
"NW_INIT state" on page
EXCEPTION state (see
12).
MEANING
MEANING
INSTRUCTION MANUAL
12).
11