Datalogic AMT58 Series Manual page 162

6004-00 Position value
[Unsigned32, ro]
This object contains the position value of the encoder, transmitted
value is calculated considering the scaling values, bit 2 Scaling
function of the object
6500-00 Operating status
[Unsigned16, ro]
Bit Function
0
Code sequence
1 not used
2
Scaling function
3 ... 15 not used
Code sequence
It shows the currently set value that is entered through the bit 0 Code
sequence in the parameter
bit is "=0" the output encoder position value has been set to
increment when the shaft rotates clockwise; if the bit is "=1" instead
the output encoder position value has been set to increment when
the shaft rotates counter-clockwise. For any further information on
setting and using the counting direction function refer to
Operating parameters
Scaling function
It shows the currently set value that is entered through the bit 2
Scaling function in the parameter
In other words, it is intended to show whether the scaling function is
enabled or disabled. If the value is "=0" the scaling function is
disabled; if the value is "=1" instead the scaling function is enabled.
For any further information on setting and using the scaling function
refer to the
6000-00 Operating parameters
6000-00 Operating
bit = 0
CW
Clockwis
e
Disabled
6000-00 Operating
parameter on page 49.
6000-00 Operating
AMT58x-EC EtherCAT®
parameters.
bit = 1
CCW
Counter
clockwise
Enabled
parameters. If the
6000-00
parameters.
parameter on page 49.
53