Setting The Parameters - Datalogic AMT58 Series Manual

INTEGRATED WEB SERVER
NOTE
Press the Homepage command to move back to the Web server Home page.

SETTING THE PARAMETERS

Press the Set Registers command in the left navigation bar of the Web server Home
page to enter the Set Encoder Registers page. In this page the Profinet encoder parame-
ters are displayed and their value can be changed.
For complete information on the encoder parameters please refer to
Parameters, starting on page 62
Figure 5. Set Encoder Registers page
A soon as you press the Set Registers command a warning message (Are you sure you
want to change Registers Values?) appears on the screen: it warns the operator about
the awkwardness of the operation, thus he is required to confirm the procedure before
continuing.
Press the OK button to proceed, otherwise press the EXIT button to abort the proce-
dure. The Set Registers canceled! message will appear on the screen. Press the OK but-
ton to move back to the Web server Home page.
If you confirm the procedure, the Set Encoder Registers page will appear on the screen.
The values that are currently set in the encoder are displayed in the READ column.
94
AMT58...PN
The parameters in the Encoder Information page cannot be changed. To
change the set values please enter the Set Registers page (see " Setting the
Parameters" on page 94 ).
.
Encoder